OTTP Throw Out Bearing Spacer

Whenever you replace your clutch you should measure your air gap to make sure you won't be over extending your throw out bearing. We offer these spacers to shim the throw out bearing so your air gap is correct. These install between your transmission case and throw out bearing. Even the factory clutch has gone through design changes over the years and may not be the same installed height as your original clutch was.

One billet aluminum spacer in .200" or .250" thickness. (custom thickness is available and made to order, custom size are not returnable.)

Three longer bolts.

F23, F35, and F40 transmissions with a FTE brand throw out bearing. If your throw out bearing has a loose o-ring on the backside these will not work.